Relative Field Strength Meter For A DMM

Many passive field
strength meters have appeared in the past, typically using a 50mA analog
meter movement if reasonable sensitivity was to be obtained. This
circuit is similar but has the advantage that it works with the
high-impedance load of a digital multimeter, typically switched to the
200mV range. The sensitivity is adequate for low power equipment like CB
radios, cordless phones and model R/C sets (cars, model airplanes,
etc). For best results, use OA81 or similar germanium diodes. Modern
Schottky signal diodes could also be used but the results are not as
good. The circuit can be wired directly into a small plastic box with
protruding banana posts to match the terminals on your DMM. A banana jack can also be used for the antenna which could be just a 500mm length of wire as a starting point.

Comments are closed.