Opamp VHF FM Transmitter

Opamp VHF FM Transmitter

Circuit diagram:

Circuit :

Circuit Description

ICs that in the past were far too expensive for the hobbyist tend to
be more favourably priced these days. An example of this is the AD8099
from Analog Devices. This opamp is available for only a few pounds. The
AD8099 is a very fast opamp (1600 V/ms) and has high-impedance inputs
with low input capacitance. The bandwidth of the opamp is so large that
at 100 MHz it still has a gain of nearly 40. This means that this opamp
can be used to create an RC oscillator. The circuit presented here
realises that.

The circuit has a few striking characteristics. Firstly, unlike
normal oscillators that contain transistors this one does not have any
inductors. Secondly, there is no need for a varicap diode to do the FM
modulation. The opamp is configured as a Schmitt trigger with only a
small amount of hysteresis. The output is fed back via an RC circuit. In
this way, the trimmer capacitor is continually being charged and
discharged when the voltage reaches the hysteresis threshold. The output
continually toggles as a consequence.

This results in a square wave output voltage. With a 10-pF trimmer
capacitor the frequency can be adjusted into the VHF FM broadcast band
88-108 MHz). The frequency of the oscillator is stable enough for this.
The output voltage is about 6 Vpp at a power supply voltage of 9 V. The
transmitter power amounts to about 50 mW at a load of 50R. This is about
20 times as much as the average oscillator with a transistor. With a
short antenna of about 10 cm, the range is more than sufficient to use
the circuit in the home as a test transmitter.

Because the output signal is not free from harmonics the use of an
outdoor antenna is not recommended. This requires an additional
filter/adapter at the output (you could use a pi-filter for this). The
FM modulation is achieved by modulating the hysteresis, which influences
the oscillator frequency. An audio signal of about 20 mVpp is
sufficient for a reasonable output amplitude. The package for the opamp
is an 8-pin SOIC (provided you use the version with he RD8 suffix). The
distance between the pins on this package is 1/20 inch 1.27 mm).

This is still quite easy to solder with descent tools. If SMD parts
are used for the other components as well then the circuit can be made
very small. If necessary, a single transistor can be added to the
circuit to act as microphone amplifier. The power supply voltage may not
be higher than 12 V, because the IC cannot withstand that. The current
consumption at 9 V is only 15 mA. As with all free-running oscillator
circuits, the output frequency of this specimen is also sensitive to
variations of the power supply voltage.

For optimum stability, a power supply voltage regulator is essential.
As an additional design tip for this circuit, we show an application as
VCO for, for example, a PLL circuit. When the trimmer capacitor is
replaced with a varicap diode, the frequency range can be greater than
that of an LC oscillator. That’s because with an LC-oscillator the range
is proportional to the square root of the capacitance ratio. With an RC
oscillator the range is equal to the entire capacitance ratio. For
example: with a capacitance ratio of 1:9, an LC oscillator can be tuned
over a range of 1:3.

With an RC oscillator this is 1:9. For the second tip, we note that
the circuit can provide sufficient power to drive a diode mixer (such as
a SBL-1) directly. This type of mixer requires a local oscillator
signal with a power from 5 to 10 mW and as already noted, this
oscillator can deliver 50 mW. A simple attenuator with a couple of
resistors is sufficient in this case to adapt the two to each other.

Comments are closed.