NiCd Battery Charger With Reverse Polarity Protection

Small and portable unit, Can charge multiple batteries at once

This NiCd battery Charger can charge up to 7 NiCd batteries
connected in series. This number can be increased if the power supply is
increased with 1.65V for each supplementary battery. If Q2 is mounted
on a proper heatsink, the input voltage can be increased at a maximum of
25V. Unlike most of comercial NiCd chargers available on the market,
this charger has a reverse polarity protection. Another great quality is
that it does not discharge the battery if the charger is disconnected
from the power supply.

Usually , NiCd batteries must be charged in 14 hours at a charging
current equal with a tenth percent from battery capacity. For example, a
500 mAh is charged at 50 mA for 14 hours. If the charging current is
too high this will damage the battery. The level of charging current is
controlled with P1 between 0 mA – 1000 mA. Q1 is opened when the NiCd
battery is connected with the right polarity or if the output terminals
are empty. Q2 must be mounted on a heatsink. If you cannot obtain a
BD679, then replace it with any NPN medium
power Darlington transistor having the output parameters at 30V and 2A.
By lowering R3 value the maximum output current can be increased up to
1A.

NiCd Battery Charger With Reverse Polarity Protection

NiCd Battery Charger With Reverse Polarity Protection

Parts:

P1 = 1K
R1 = 680R
R2 = 47K
R3 = 1R-3W
Q1 = BC557
Q2 = BD679 (Darlington)
D1-D5 = 1N4148
D6 = 1N4001

Comments are closed.