Car Battery Failure Detector

A car battery
deteriorates in use and its life seldom exceeds four years. When new,
its voltage may drop to only 2V while cranking the engine. As the
battery ages, its internal impedance increases and so the voltage drop
while cranking also increases, until ultimately the drop is high enough
to prevent the engine from starting. This gradual increase in voltage
drop while cranking can be used as an early warning of looming battery
failure and so this circuit triggers an alarm when the battery voltage
drops to 8V during cranking. IC1 is a precision 2.5V device used as the
reference for two comparators based on IC2, an LM358 dual op amp.

Car Battery Failure Detector Circuit

Car Battery Failure Detector Circuit Diagram

IC2a monitors the voltage from trimpot VR1 and normally its output
at pin 1 will be low while the output of IC2b will be high and LED1 will
be green. When pin 2 of IC2a falls below pin 3, its output at pin 1
will go high to drive the red section of LED1 to indicate a fault. At
the same time, IC2b inverts the signal from pin 1 and its output at pin 7
goes low and turns off the green section of LED1 to indicate a fault.
Since the battery voltage drop occurs momentarily while cranking, a more
permanent indication of the fault is provided by flashing LED2. When
IC2a’s output goes high momentarily, the SCR is latched and LED2 flashes and can only be deactivated by pressing pushbutton S1.

Author: Victor Erdstein – Copyright: Silicon Chip Electronics

Comments are closed.