60 LED Clock

This months project is
based on the 4017 chip that we used in a project last month. If you
haven’t had a chance to review the basics of the 4017 chip you may want
to review the info presented in June’s project of the month. As you can
see see we have changed the circuit a little. For example, the 4093 NAND
gate is now set to exactly 1 second clock pulses. The clock rate is
determined by the resistor and capacitor combination on the 4093.

60 LED clock

60 LED clock

If the resistor is 220k ohms and the capacitor is 4.7uf then the
output will be 1 second clock pulses. To increase the clock rate you
should decrease the value of the resistor or capacitor. To decrease the
clock rate you should increase the value of the resistor or capacitor.
Please remember to ground all unused legs of the 4093 or noise in the
circuit will occur and cause the clock to malfunction. Therefore, ground
pins 5,6,8,9,12, and 13. To operate the circuit simply move the switch
from STOP to RUN.

Comments are closed.