12VDC Fluorescent Lamp Inverter with Mosfet

It uses a normal 120 to 6V stepdown transformer in reverse to step 12V to about 350V to drive a lamp without the need to warm the filaments.

Q1 must be installed on a heat sink. A 240V to 10V transformer will work better then the one in the parts list. The problem is that they are hard to find. This circuit can give a nasty (but not too dangerous) shock. Be careful around the output leads.

Read More Source :

http://www.aaroncake.net/circuits/flampdrv.asp

Thank you.

Comments are closed.